User Tools

Site Tools


h2o_rocket:h2o_rocket

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
h2o_rocket:h2o_rocket [2020/02/01 11:32] midiwidih2o_rocket:h2o_rocket [2023/07/22 11:50] (current) – [Date TBD - launch series of the upgraded water rocket v2.6] midiwidi
Line 3: Line 3:
 |{{:h2o_rocket:state_diagram.png?800x654|pic can not be displayed}}|This is the state diagram of the water rocket.| |{{:h2o_rocket:state_diagram.png?800x654|pic can not be displayed}}|This is the state diagram of the water rocket.|
  
-<font inherit/inherit;;inherit;;#ffffff>first launch</font> +===== 19.01.2020 - First launch of the upgraded water rocket v2.0 =====
- +
-<font inherit/inherit;;inherit;;#ffffff>19.01.2020 - launch 01</font>+
  
 {{youtube>g4kU_LOwwg0?large}} {{youtube>g4kU_LOwwg0?large}}
  
-19.01.2020 - launch 02+Many improvements were made including 
 + 
 +  * New fin design (mechanically much more robust) 
 +  * Electronics payload compartment accommodating, accelerometers, gyroscopes, magnetometer, barometric pressure sensor, 2MP camera, LiPo battery and charge controller, a servo and a WiFi enabled ESP8266 32bit Microcontroller acting as the on-board computer 
 +  * Spring loaded parachute, deployed at apogee using a servo (apogee is detected via the rockets attitude determined from magnetometer data) 
 + 
 +===== 07.06.2020 - launch series of the upgraded water rocket v2.5 ===== 
 + 
 +{{youtube>8ACIOvbvEds?large}} 
 + 
 +<font inherit/inherit;;inherit;;#ffffff>The changed to the v2.0 model included</font> 
 + 
 +  * New 30'' nylon parachute (the bin liner version didn't support the acting forces) 
 +  * Rubber band shock absorber in the parachute harness 
 +  * Adjustments to the parachute release point 
 +  * Improvements in the on-board software 
 +  * changes to the nozzle design as the epoxy didn't withstand the pressure 
 +  * rubber gaskets were added to the tornado couplings between the sections 
 +  * added another bottle section (new volume → see below) 
 +  * adjustment on the launchers nozzle latch to support the new nozzle design 
 +  * repairs of damages due to rough landings from previous flights 
 +  * higher pressure at launch up to 110 psi 
 + 
 +__Datasheet__ 
 +  * total volume: 4.73 l 
 +  * empty weight: 426 g 
 +  * parachute diameter: 760 mm 
 +  * nozzle diameter: 9 mm 
 +  * height: 1320 mm 
 + 
 +===== Date TBD - launch series of the upgraded water rocket v2.6 =====
  
-~~DISCUSSION~~+The changes planned include
  
-\\+  * increased nozzle diameter of 10 mm (drilled open) 
 +  * Improvements in the on-board software 
 +  * increased sensor data rate 
 +  * replace RGB camera which was read by the onboard computer directly with a standalone HD camera (including SD card - just activated by the onboard computer) which saves computational resources 
 +  * Launch tube
  
  
h2o_rocket/h2o_rocket.1580556722.txt.gz · Last modified: 2020/02/01 11:32 by midiwidi